Omega Engineering U24Y101 Dépliant

OMEGA’s U24Y101 24 VDC Power
Supply provides low cost DC power
suitable for driving process current
loops, transducers, relays, electro-
mechanical timers, and small motors.
All components are rated to insure high
reliablility, and built-in fusing prevents
damage due to short-circuits or
prolonged overloading.

There are two models:

for 120 Vac power;

for 220 Vac power

Either model can be converted to the
other by a solder pad change which is
explained below.

Remove the packing list and verify that
all equipment has been received. If
there are any questions about the
shipment, please call OMEGA
Customer Service Department at 
1-800-622-2378 or (203) 359-1660.

Upon receipt of the shipment, inspect
the container and equipment for any

signs of damage. Take particular note
of any evidence of rough handling in
transit. Immediately report any damage
to the shipping agent.

The carrier will not honor any claims
unless all shipping material is saved for
their examination. After examining and
removing contents, save packing
materials and carton in the event
reshipment is necessary.

The U24Y101 is provided with a
predrilled base plate for surface
mounting. the power supply should be
mounted in an open area with
unrestricted air movement.
Connections for AC power and DC
output are made via the four position
terminal block. The power can be 120
or 220 VAC and is user selectable by
means of internal jumpers.

1. Remove the screws securing the

bottom covers to gain access to the
printed circuit board.

2. Locate the three solder jumpers

shown in Fig. 1.

a) For 120 VAC operation install

solder jumpers at locations A & B
and remove jumper C.

b) For 220 VAC remove solder

jumper from A & B and install
solder jumper at C.

3. Relabel unit to reflect power change.

Input Power:

120 VAC (Std) or 
220 VAC (Opt) ± 10%

Output Voltage:

24 VDC ± 5%

Output Current:

1 Amp (max)

Load/Line Regulation:

± 2%

Output Protection:

Current Limited and
Thermal Limited

Input Protection:

0.5 Amp Fuse

Operating Temp:

–20 to 60 Deg. C

Storage Temp:

–30 to 70 Deg. C

Size:

See Fig. 2

.150 Dia.

4 PLS

1. AC IN
2. AC IN
3. DC OUTPUT (+)
4. DC OUTPUT (--)

TERMINAL BLOCK

CONNECTIONS

NOTES:

ALL DIMENSIONS IN INCHES

CASE HEIGHT: 2.520"
(Add for Terminal Block)

.150
.150

7.625

7.00

1

2

3

4

FUSE

MEC 24-1000

made in USA

LINEAR POWER SUPPLY

2.25

3.00

A

C

B

Printed Circuit Board

OMEGA

MODEL U24Y101

Figure 1

Figure 2