Nikon NP64 Manuale Utente

3. Projecting an Image (Basic Operation)

＋

AUTO

ADJ.

ON/STAND BY

FOCUS

LAMP
STATUS

POWER

SOURCE

[Poor picture]

[Normal picture]

➏

Optimizing RGB Picture Automatically

Adjusting the Image Using Auto Adjust

This adjustment may be necessary when you connect your computer for the first time.

Adjusting with buttons on the cabinet

• Press the

◀ button with no menus displayed.

An RGB image will be optimized automatically after a few seconds.

Adjusting with the remote control

• Press the AUTO ADJ. button to optimize an RGB image automatically.

NOTE:

Some signals may take time to display or may not be displayed correctly.

• NP63/NP43: The Auto Adjust function does not work for component and video signals.

• NP64/NP54: The Auto Adjust function does not work for component/video signals, and the Viewer source.

• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust HORIZONTAL/VERTICAL, CLOCK and PHASE manu-

ally. (

→ page

• If performing the Auto Adjust function does not correct image positioning, vertical stripes (banding) or horizontal noise, per-

form the [HORIZONTAL], [VERTICAL], [CLOCK] or [PHASE] function from the menu to optimize the image. (

→ page

• Performing the [HORIZONTAL], [VERTICAL], [CLOCK] or [PHASE] function will store the adjustment values of the currently

projected source into the projector’s memory.

• The next time the same source (same resolution, horizontal and vertical frequencies) is projected; the projector will call up

from memory the stored values for the source.

• To clear the stored adjustment values, select the [RESET]

→ [CURRENT SIGNAL] or [ALL DATA] from the menu to reset the

adjustment values.