Nikon NP64 Manuale Utente
70
6. Using On-Screen Menu
Setting ID to the Projector [CONTROL ID]
You can operate multiple projectors separately and independently with the single remote control that has the
CONTROL ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projec-
tors together using the single remote control. To do so, you have to assign an ID number to each projector.
CONTROL ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projec-
tors together using the single remote control. To do so, you have to assign an ID number to each projector.
CONTROL ID NUMBER ������Select a number from 1 to 254 you wish to assign to your projector�
CONTROL ID ����������������������Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID
CONTROL ID ����������������������Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID
setting�
NOTE:
• When [ON] is selected for [CONTROL ID], the projector cannot be operated by using the remote control that does not support
the CONTROL ID function. (In this case the buttons on the projector cabinet can be used.)
• Your setting will not be affected even when [RESET] is done from the menu.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Con-
trol ID.
Assigning or Changing the Control ID
1. Turn on the projector.
2. Press the ID SET button on the remote control.
The CONTROL ID screen will be displayed.
1. Turn on the projector.
2. Press the ID SET button on the remote control.
The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the pro-
jector cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the
inactive projector, assign the control ID used for the projector by using the following procedure (Step 3).
inactive projector, assign the control ID used for the projector by using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and holding the ID SET button on the remote con-
trol.
Example:
To assign “3”, press the “3” button on the remote control.
No ID means that all the projectors can be operated together with a single re-
To assign “3”, press the “3” button on the remote control.
No ID means that all the projectors can be operated together with a single re-
mote control. To set “No ID”, enter “000” or press the CLEAR button.
TIP: The range of IDs is from 1 to 254.
TIP: The range of IDs is from 1 to 254.
4. Release the ID SET button.
The updated CONTROL ID screen will be displayed.
NOTE:
The updated CONTROL ID screen will be displayed.
NOTE:
• The IDs can be cleared in a few days after the batteries are run down or removed.
• Accidentally pressing any one of the buttons of the remote control will clear currently
specified ID with batteries removed.
＋
＋