Nikon NP4100 Manuale Utente
2. Installation and Connections
27
r
Replacing Color Wheel
The NP4100/NP4100W projector comes with a four-segment color wheel installed. An addi-
tional six-segment color wheel comes included. To replace the color wheel (located under the
lamp cover adjacent to lamp 1) refer to the following guide.
tional six-segment color wheel comes included. To replace the color wheel (located under the
lamp cover adjacent to lamp 1) refer to the following guide.
Note:
• Before replacing the color wheel, be sure to turn off the projector, wait until the
cooling fans stop, and turn off the main power switch.
• Before replacing the color wheel, be sure to turn off the projector, wait until the
cooling fans stop, and turn off the main power switch.
• Wait until the lamp house and the color wheel cool off.
• Do not touch the disk of the color wheel. Doing so may scratch the disk or leave
fingerprints, causing the image quality to degrade.
fingerprints, causing the image quality to degrade.
• Heed the following information if you own two or more NP4100/NP4100W
projectors:
When replacing or re-installing the color wheel, the original color wheel pre-
installed or supplied as an accessory must go back to its original projector. Your
color wheel and projector color wheel cover are given an identification number. Be
sure to use the color wheel pre-installed or supplied with your projector to match
its identification number.
projectors:
When replacing or re-installing the color wheel, the original color wheel pre-
installed or supplied as an accessory must go back to its original projector. Your
color wheel and projector color wheel cover are given an identification number. Be
sure to use the color wheel pre-installed or supplied with your projector to match
its identification number.
If you remove a color wheel from one NP4100/NP4100W projector and re-install it
into another NP4100/NP4100W projector, performance may be compromised.
into another NP4100/NP4100W projector, performance may be compromised.
• Be sure turn off the main power switch before replacing the color wheel. Failure
to do so may result in electrical shock or damage to the projector, and cause an ir-
regular color of the projected image.
to do so may result in electrical shock or damage to the projector, and cause an ir-
regular color of the projected image.
1.
Loosen the captive
screw (A) on the lamp
cover.
screw (A) on the lamp
cover.
2.
Remove the lamp cover
by sliding in the direc-
tion of the arrow (B).
by sliding in the direc-
tion of the arrow (B).