Nikon NP4100 Manuale Utente
38
3. Projecting an Image (Basic Operation)
Turning on the Projector
Once the projector is correctly located and the power cable and other connections are in
place, it is important that the projector is powered on correctly in order to avoid damage to
components and unnecessary wear and tear. Refer to the following guide to power on the
projector.
place, it is important that the projector is powered on correctly in order to avoid damage to
components and unnecessary wear and tear. Refer to the following guide to power on the
projector.
1.
Connect the power cable (A).
Press the main power switch ( I )
to the on position as shown (B).
The power LED lights orange.
Press the main power switch ( I )
to the on position as shown (B).
The power LED lights orange.
B
A
2.
Press the On/Standby button
once (see
once (see
power LED lights green and the
internal cooling fan starts.
internal cooling fan starts.
3.
After approximately 10 seconds,
the power LED flashes intermit-
tently green.
the power LED flashes intermit-
tently green.
4.
The Lamp1 and Lamp2 LEDs
light green and the Power LED
flashes more rapidly.
light green and the Power LED
flashes more rapidly.
5.
Once the power LED is lit
solidly green, the projector is
ready for use.
solidly green, the projector is
ready for use.
Note:
If any of the LEDs remain flashing or blink there may be a problem with the startup.
Please refer to the Troubleshooting section on page
If any of the LEDs remain flashing or blink there may be a problem with the startup.
Please refer to the Troubleshooting section on page