NEC VE282 Manuale Utente

3. Projecting an Image (Basic Operation)

Adjustable Tilt Foot

Exhaust
Vent

Adjust the Tilt Foot

1. Lift the front edge of the projector.

CAUTION:

Do not try to touch the Exhaust Vent during Tilt Foot adjustment as
it can become heated while the projector is turned on and after it is
turned off.

2. Rotate the Adjustable Tilt Foot on the front of the projector to

extend the adjustable tilt foot.

The tilt foot can be extended up to 0.7 inch/18 mm.

There is approximately 5 degrees (up) of adjustment for the front of
the projector.

CAUTION:

• Do not use the tilt-foot for purposes other than originally intended.

Misuses such as using the tilt foot to carry or hang (from the wall or

ceiling) the projector can cause damage to the projector.

Adjusting the left and right tilt of an image [Rear foot]

1. Remove the spacer (black rubber) from the rear foot.

Keep the spacer for future use.

2. Rotate the rear foot.

The rear foot can be extended up to 0.4 inch/10 mm, shorten by

0.3inch/7mm. Rotating the rear foot allows the projector to be placed
horizontally.

NOTE: After using the projector, attach the spacer to the rear foot.

Spacer (black
rubber)

Rear foot

Down