NEC 2400 ipx Manuale Utente
CHAPTER 3
NDA-24318
Page 24
Issue 1
Issue 1
OFFICE DATA PROGRAMMING
11.
This feature does not support Broad Band Services H0/H1. Therefore, when assigning the IPTRK circuit
card routes by the ARTD command, enter BOB = 0.
card routes by the ARTD command, enter BOB = 0.
12.
This feature can use link re-connection function. Service conditions are the same as those for the normal
CCIS network.
CCIS network.
13.
PAD can be provided for RECEIVE control only.
14.
On a conference call via IPTRK, Echo Canceller cannot be activated when using certain kinds of telephone
sets (generally analog telephones).
sets (generally analog telephones).
15.
During IPTRK circuit card-related tandem connection, speech quality can become poor, or dual
connection failure may occur. DTMF and FAX relay cannot be used.
connection failure may occur. DTMF and FAX relay cannot be used.
2.4 Data Programming
To activate this service via the Intranet, perform the data programming as follows:
Note:
When office data is assigned/modified, be sure to initialize the IPTRK circuit card (by flipping its MB key
OFF
OFF
→
ON
→
OFF).
STEP 1:
Assignment of basic CCIS network data
Referring to the NEAX2400 IPX No. 7 CCIS System Manual, assign all the basic data (such as ASYD,
ARTD, ATRK, ADPC, ACSC, ACIC1, ACIC2, MBTK, etc.), necessary for the establishment of a
CCIS Tie line.
When assigning this data, consider the following:
ARTD, ATRK, ADPC, ACSC, ACIC1, ACIC2, MBTK, etc.), necessary for the establishment of a
CCIS Tie line.
When assigning this data, consider the following:
•
Enter IPTRK = 1 for B-channel route on the ARTI command.
•
For the port assignment (B-ch) of the IPTRK circuit card, see
.