IMC Networks Giga-AcessEtherLinx-II Manuale Utente
5
SNMP, Telnet and Console Management
SNMP, Telnet, and iConfig management channels are always supported through the
Giga-AccessEtherLinX-II Uplink Port. This provides a higher level of security so end
users cannot access management, alter settings, etc. Management through other
ports can be supported through unit configuration.
Giga-AccessEtherLinX-II Uplink Port. This provides a higher level of security so end
users cannot access management, alter settings, etc. Management through other
ports can be supported through unit configuration.
In order for the Giga-AccessEtherLinX-II to support SNMP management, the unit must
be assigned IP configuration information (e.g., IP address, subnet mask, etc.) There
are five ways to do so:
be assigned IP configuration information (e.g., IP address, subnet mask, etc.) There
are five ways to do so:
• Using iConfig (IP-Less on same Ethernet Domain)
• Host-Remote IP-Less from an iMcV-GigaFiberLinX-II
• Using the console DB9 port located on the back of the unit
• Host-Remote IP-Less from an iMcV-GigaFiberLinX-II
• Using the console DB9 port located on the back of the unit
• Using DHCP (Dynamic Host Control Protocol); DHCP must be enabled
through the console configuration or Telnet
• Telnet (Default IP=10.10.10.10; subnet mask=255.0.0.0)
In addition to assigning an IP Address and subnet mask, the end user can create
community strings, assign access rights, and configure traps for total remote
management.
community strings, assign access rights, and configure traps for total remote
management.
About Console Port Configuration
Use the console DB-9 port on the back of the unit to access the internal Command
Line Interface (CLI).
Line Interface (CLI).
To connect the Giga-AccessEtherLinX-II to a terminal/computer, use a straight-
through (pin-to-pin) cable. (If the computer/terminal has a COM port using a
connection not compatible with a DB-9 connector, use the pin connection chart
shown below for reference in making a cable.) Make sure the cable length is less
than 50 feet (15.24m). Plug one end of the cable into the DB-9 connector and the
other into the appropriate computer/terminal port. Set the computer/terminal for VT-
100 emulation, with: 38.4K baud, 8 data bits, 1 stop bit, no parity and no flow
control
through (pin-to-pin) cable. (If the computer/terminal has a COM port using a
connection not compatible with a DB-9 connector, use the pin connection chart
shown below for reference in making a cable.) Make sure the cable length is less
than 50 feet (15.24m). Plug one end of the cable into the DB-9 connector and the
other into the appropriate computer/terminal port. Set the computer/terminal for VT-
100 emulation, with: 38.4K baud, 8 data bits, 1 stop bit, no parity and no flow
control
.
Console RS-232 Interface
DB-9 Pin #
Function
2 Transmit
(OUT)
3 Receive
(IN)
5 Ground
1, 4, 6 - 9
Reserved