Cabletron Systems 2H22 Manuale Utente

To set the Operational Mode for individual ports, proceed as follows:

Use the arrow keys to highlight the Operation Mode field adjacent to 
the number of the port(s) that you plan to change.

Press the SPACE bar until the appropriate mode, FULL DUPLEX or 
STANDARD ENET displays in the field.

Use the arrow keys to highlight the SAVE command on the bottom 
line of the screen.

Press ENTER. The message “SAVED OK” displays. 

To set the Operation Mode for all ports (1-24, or higher), proceed as 
follows:

Use the arrow keys to highlight the SET ALL PORTS field.

Press the SPACE bar until you see FULL or STANDARD.

Use the arrow keys to highlight the SAVE command on the bottom 
line of the screen.

Press ENTER. The message “SAVED OK” displays.

The High Speed Interface Configuration Menu screen, 

, applies 

to the Fast Ethernet Interface Modules and the High Speed Interface 
Module. 

The Operation Mode for

 

the first 12 ports can be changed on 

the first screen. To display the Operation Mode for additional 
groups of twelve ports (13 – 24, 25 – 36, and 37 – 48), use the 
arrow keys to highlight the Ports [xx-xx] field and press 
ENTER. 

This High Speed Interface Configuration Menu screen does not 
display unless an optional interface module is installed: one or 
two Fast Ethernet Interface Modules, or High Speed Interface 
Module (HSIM), depending on what the host SmartSwitch 
supports.