Cabletron Systems 3H08-04 Manuale Utente

Using Local Console Manager, you can get the status of the switch 
module ports by typing

 status

 for the appropriate switch module port. A 

sample display is shown below.

ATX >status 3
Port 3 (1st port on module 3) status

Type: 100 Mbps Ethernet/802.3 CSMA/CD
Bridging: Transparent/Translating

Routing: IP Routing

Enabled/Disabled: Bridging/Routing functions enabled

Spanning Tree: Forwarding

Pkts Transmitted: 2021469

Pkts Received: 1078

Small Buffers: 36

Rx_Q Overflows: 0

Carrier Losses: 0

Total Collisions: 4

Excess Collisions: 0

Rx FCS/Align Errs: 0

Internal Rx Errs: 0

Internal Tx Errs: 0

The status of a switch module port includes the following information:

•

Type - 100 Mbps Ethernet/802.3 CSMA/CD

•

Bridging - which functions have been enabled for bridging (see the 

bridge

 command).

•

Routing - which functions have been enabled for routing (see 

iproute

 

and 

ipxroute

 commands).

•

Enabled/Disabled - enabled if it is operational or, disabled if you used 
the 

disable

 command to disable it. If the port is enabled but not 

operational, its status will be broken. (A port could be broken if it is so 
badly misconfigured as to be unusable. You might see a status of 
broken if a FDDI or Token Ring port can’t connect to a logical ring, or 
if an Ethernet or Fast Ethernet port continually fails as it tries to 
transmit.)