Cisco Systems Cisco MGX 8850 Manuale Utente
2-57
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2
Shelf Management Commands
dspipif
dspipif
Display IP Interface Configuration
Display configuration and other information for either one or all IP interfaces on the current PXM45. If
you request all interfaces by entering dspipif with no parameters, the display shows information for all
interface types. The displayed information comes from the current state of the interface and the
configuration specified through ipifconfig. The information consists of the:
you request all interfaces by entering dspipif with no parameters, the display shows information for all
interface types. The displayed information comes from the current state of the interface and the
configuration specified through ipifconfig. The information consists of the:
•
Configuration (see ipifconfig for descriptions).
•
Operational state.
•
Statistics (including transmitted and received packets and errors).
Cards on Which This Command Runs
PXM45
Syntax
dspipif
[interface]
Syntax Description
Related Commands
ipifconfig, dspipifcache
Attributes
Example
Display information for all IP interfaces. The output shows that no configuration exists for the ATM
interface but do for Ethernet and SLIP. Note that for each interface in the current release, the “unit
number” has no meaning. The Flags field for Ethernet shows that the interface is UP, a broadcast address
has been configured, ARP is enabled, and that the interface is running. (See the ipifconfig description
for the meaning of these parameters. The output also shows the number of packets that have crossed the
Ethernet interface. Although a configuration exists for SLIP, the display shows that no packets have
crossed this interface.
interface but do for Ethernet and SLIP. Note that for each interface in the current release, the “unit
number” has no meaning. The Flags field for Ethernet shows that the interface is UP, a broadcast address
has been configured, ARP is enabled, and that the interface is running. (See the ipifconfig description
for the meaning of these parameters. The output also shows the number of packets that have crossed the
Ethernet interface. Although a configuration exists for SLIP, the display shows that no packets have
crossed this interface.
interface
(Optional) An alphanumeric string that identifies a type of interface for
display.Without this parameter, the system displays the configuration state of all
interface types. The choices for interface are as follows:
display.Without this parameter, the system displays the configuration state of all
interface types. The choices for interface are as follows:
•
lnPci0 specifies the Ethernet interface (the default on power-up).
•
atm0 specifies the ATM interface.
•
sl0 specifies the SLIP interface
Log: no log
State: active, standby, init
Privilege: ANYUSER