Cisco Systems Cisco MGX 8850 Manuale Utente
2-90
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2
Shelf Management Commands
setipconndebug
setipconndebug
Set IP Connection Debug
Specify a debug mode and whether to use a console for debugging IP connectivity. This command
requires SUPER_GP privilege. After you set the debug level, a status message states the current level.
requires SUPER_GP privilege. After you set the debug level, a status message states the current level.
Syntax
setipconndebug [-console | -noconsole] [debuglevel]
Syntax Description
Attributes
Example
Set IP connection debug to console and specify a debug level of 20 for SVC call events.
node19.8.PXM.a > setipconndebug -console 20
-console | -no console
Configure where to run setipconndebig: console (ASCII) terminal or
elsewhere.
elsewhere.
debuglevel
Specifies a debug level. To select one or all of the following levels, enter the
associated hexadecimal number and include the leading “0x” (see example):
associated hexadecimal number and include the leading “0x” (see example):
•
No Logging (0x0)
•
Task Errors (0x1)
•
Task Debug (0x2)
•
ATM Protocol (0x4)
•
Task Startup (0x8)
•
Task Events (0x10)
•
SVC Call Events (0x20)
•
ATMARP Protocol (0x40)
•
Task Timers (0x80)
•
Interface Cache (0x100)
•
Subtask Events (0x200)
•
DISKDB Events (0x400)
•
RAMDB Events (0x800)
•
TRAP Events (0x1000)
•
All Logging (0xffffffff)
Log: no log
State: active, standby, init
Privilege: SERVICE_GP