Cisco Systems Cisco MGX 8850 Manuale Utente
3-32
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3
Equipment and Resource Provisioning
cnfpart
cnfpart
Configure Resource Partition
Modifies a resource partition. A resource partition on an AXSM consists of minimum and maximum
percentages of bandwidth, a VPI/VCI range, and a minimum and maximum number of connections
available to a network control application. The current network controller is PNNI. Refer to the
description of addpart for information on resource partitions.
percentages of bandwidth, a VPI/VCI range, and a minimum and maximum number of connections
available to a network control application. The current network controller is PNNI. Refer to the
description of addpart for information on resource partitions.
Note
The cnfpart and cnfrscprtn commands are identical. The name ‘cnfrscprtn’ is consistent with the
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
Cards on Which This Command Runs
AXSM
Syntax
cnfpart
-if <if>
-id <partionID>
-ctlr <controllerID>
-emin <egrMinBw>
-emax <egrMaxBw>
-imin <ingMinBw>
-imax <ingMaxBw>
-vpmin <minVpi>
-vpmax <maxVpi>
-vcmin <minVci>
-vcmax <maxVci>
-mincon <min connections>
-maxcon <max connections>
Note
The maximum number of connections must be greater than 10.
Syntax Description
Note
On a virtual trunk, the min_vpi and max_vpi must be the same.
-if
Logical interface (port) number. For AXSM, the range is 1–60.
This parameter is the same as the ifNum that appears in other commands.
-id
Specifies the number of the partition in the range 1–5.
-ctlr
Specifies the number of the controller in the range 1–20.
-emin
Specifies the guaranteed percentage of egress bandwidth. Each unit of egrMinBw is
0.00001 of the total bandwidth on the port. (An egrMinBw of 1000000 = 100%.) This
approach provides a high level of granularity.
0.00001 of the total bandwidth on the port. (An egrMinBw of 1000000 = 100%.) This
approach provides a high level of granularity.