Cisco Systems Cisco MGX 8850 Manuale Utente
3-81
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3
Equipment and Resource Provisioning
dsppart
dsppart
Display Resource Partition
Displays information about one resource partition. The displayed information is shown in the example.
Note
The dsppart and dsprscprtn commands are identical. The name ‘dsprscprtn’ is consistent with the
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
Note
The connection count includes control VCs when you execute dsppart on the CLI of a service
module. However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the
display does not include control VCs.
module. However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the
display does not include control VCs.
The total number of connections in the display includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
Cards on Which This Command Runs
AXSM
Syntax
dsppart <ifNum> <partId>
Syntax Description
Related Commands
addpart, cnfpart, delpart, dspparts
Attributes
if_num
Logical interface (port) number. For AXSM, the range is 1–60.
part_id
Partition identifier in the range 1–5.
Log: no log
State: active, standby
Privilege: ANYUSER