Cisco Systems Cisco MGX 8850 Manuale Utente
3-98
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3
Equipment and Resource Provisioning
dspsct
dspsct
Display SCT
Display the contents of a service class template (SCT) for either the egress or ingress direction. For
information on SCTs, see the cnfcdsct and addport description. Also, refer to the description of SCTs
in the Cisco MGX 8850 Switch Software Configuration Guide, Release 2.
information on SCTs, see the cnfcdsct and addport description. Also, refer to the description of SCTs
in the Cisco MGX 8850 Switch Software Configuration Guide, Release 2.
With the dspsct command, you can specify:
•
Egress or ingress direction
•
A particular SCT template
•
A section within the SCT (see Syntax Description for an explanation)
Note
Currently, the system does not support certain parameters in the service class templates
(SCTs), so you can specify them through addcon, cnfcon, or Cisco WAN Manager.
These parameters are (when applicable) PCR, SCR, and ICR.
(SCTs), so you can specify them through addcon, cnfcon, or Cisco WAN Manager.
These parameters are (when applicable) PCR, SCR, and ICR.
Cards on Which This Command Runs
AXSM
AXSM
Syntax
dspsct <SCT_section> <sctID> <egr | ing>
AXSM
Syntax Description
Related Commands
cnfcdsct, dspcdsct
SCT_section
A specific part of the SCT, as follows:
•
bw for bandwidth
•
gen for policing and CAC
•
cosb
•
vcThr for VC thresholds
•
cosThr for COSB thresholds
sctID
SCT identifier in the range 1–255.
egr | ing
Specifies the direction to which the template applies. Enter the entire string “eng” or
“ing.”
“ing.”