Cisco Systems Cisco MGX 8850 Manuale Utente
4-8
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4
ILMI Commands
cnfilmi
cnfilmi
Configure ILMI
The cnfilmi command lets you configure the card-level ILMI for the AXSM. Activating the card-level
ILMI through cnfilmi requires a pre-existing logical port (see addport) and resource partition (see
addrscprtn or addpart). No response appears unless an error occurs.
ILMI through cnfilmi requires a pre-existing logical port (see addport) and resource partition (see
addrscprtn or addpart). No response appears unless an error occurs.
Note
For network-level ILMI in relation to PNNI, run the PNNI-specific ILMI commands on the PXM45.
Cards on Which This Command Runs
AXSM
Syntax
cnfilmi <ifNum> -id <partitionID> -ilmi <ilmiEnable> -vpi <vpi> -vci <vci> -trap
<ilmiTrapEnable> -s <keepAliveInt> -t <pollingIntervalT491> -k <pollInctFact>
Syntax Description
Related Commands
dspilmi, dspilmis, dspilmicnt, clrilmicnt, dnilmi, upilmi
Attributes
ifNum
Logical port number. On an AXSM, the range is 1–60.
-id
Partition ID in the range 1–5. (See description of addpart or addrscprtn for information
regarding resource partition ID.)
regarding resource partition ID.)
-ilmi
Enable or disable ILMI. 1=enable. 2=disable.
-vpi
VPI for the ILMI signaling connection. The range is 0–255.
-vci
VPI for the ILMI signaling connection. The range is 0–65535.
-trap
Enable or disable ILMI trap. 1=enable. 2=disable.
-s
Keep alive interval. The range is 1–65535 seconds.
-t
Polling interval for T491 in the range 0–65535 seconds.
-k
Polling interval K in the range 0–65535 seconds.
Log: log
State: active
Privilege: GROUP1