Cisco Systems Cisco MGX 8850 Manuale Utente
4-17
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4
ILMI Commands
dspilmi
dspilmi
Display ILMI
Display the configuration for the interim local management interface (ILMI) on a specific port. The
information in the dspilmi output was configured through the cnfilmi command.
information in the dspilmi output was configured through the cnfilmi command.
Cards on Which This Command Runs
AXSM
Syntax
dspilmi <ifNum> <partId>
Syntax Description
Related Commands
cnfilmi, dspilmis, dspilmicnt, clrilmicnt
Attributes
Examples
This example show the dspilmi command line on the AXSM card.
pinnacle3.1.2.AXSM.a > dspilmi 1 1
Sig. rsrc Ilmi Sig Sig Ilmi S:Keepalive T:conPoll K:conPoll
Port Part State Vpi Vci Trap Interval Interval InactiveFactor
---- ---- ---- ---- ---- --- ------------ ---------- ----------
1 1 Off 0 16 On 1 5 4
pinnacle3.2.AXSM.a >
ifNum
Logical port number. On an AXSM, the range is 1–60.
partId
The range for partition identifier is 1–5.
Log: nolog
State: active, standby
Privilege: ANYUSER