Cisco Systems Cisco MGX 8850 Manuale Utente
4-21
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4
ILMI Commands
dsppnilmi
dsppnilmi
Display PNNI ILMI
Displays the ILMI information for a PNNI logical port. The ILMI state can be one of the following.
Note
The VC for ILMI is a control channel, but its bandwidth parameters are fixed, as follows:
PCR=1000 cps; SCR=50cps; and MBS=1024 cells.
PCR=1000 cps; SCR=50cps; and MBS=1024 cells.
The bandwidth used by ILMI (when enabled) and other control-type VCs (see cnfpnctlvc) adds to
the bandwidth load on the port. Use dspload to determine the load on port resources.
the bandwidth load on the port. Use dspload to determine the load on port resources.
Cards on Which This Command Runs
PXM45
Syntax
dsppnilmi <portid>
Syntax Description
Related Commands
dspilmi
Attributes
Disable
Protocol is not enabled on this port.
NotApplicable
This port is not accessible due to hardware-related conditions.
LostConnectivity Protocol on listening port is not enabled.
EnableNotUp
This port is not accessible due to hardware.
UpAndNormal
This port is physically up, and the protocol is enabled.
portid
The portid is the PNNI physical port. The format is
[shelf.]slot[:subslot].port[:subport]. See also
[shelf.]slot[:subslot].port[:subport]. See also
Log: nolog
State: active, standby
Privilege: ANYUSER