Cisco Systems Cisco MGX 8850 Manuale Utente
5-104
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5
PNNI Commands
dsppnni-reachable-addr
dsppnni-reachable-addr
Display PNNI Reachable Addresses
—displays the reachable PNNI addresses in the peer group.
This command displays all the reachable addresses and address prefixes in the peer group. For a
description of the items in the display, refer to the section, “
description of the items in the display, refer to the section, “
.” The display granularity depends on your parameter choice:
•
If you enter local, the display shows the port ID and the addresses directly attached to the local node.
•
If you enter network, the display shows the advertising node ID, the addresses advertised by other
nodes, and the routing parameters for each reachable node.
nodes, and the routing parameters for each reachable node.
Note
The display may not update frequently enough if you are configuring the network. You can change
timers to update more frequently, but changing timers can have unexpected effects. Before you
modify a timer, discuss it with the TAC or your Cisco representative.
timers to update more frequently, but changing timers can have unexpected effects. Before you
modify a timer, discuss it with the TAC or your Cisco representative.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-reachable-addr <local | network>
Syntax Description
local | network
Ddetermine whether the display shows the addresses of nodes that directly
connect to this switch or all nodes in the peer group.
connect to this switch or all nodes in the peer group.
Local: directly connected switches
Network: all reachable nodes in the peer group
Network: all reachable nodes in the peer group
Default: (no default)