Cisco Systems Cisco MGX 8850 Manuale Utente
6-24
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6
Logical Node, Port, and Signaling Commands
cnffltset
cnffltset
Configure Filter Set—modifies an ATM address filter set.
Use cnffltset to modify an existing filter set. This command can:
•
Add more addresses to the filter set.
•
Change the access mode or address field of a filter set entry.
After a filter is modified for a specific port, associate the filter to that port by using cnf-pnportacc.
Cards on Which This Command Runs
PXM45
Syntax
cnffltset < name >
[-address atm-address -length address-length [-plan {nsap | e164}]
[-list {calling | called}]]
[-index number]
[-accessMode {permit | deny}]
Syntax Description
name
A name for the filter set: the maximum is 30 characters.
address
The 1-40 digit NSAP or 1-15 digit E.164 address. You can add the address to a filter
set. The default is modifying the accessMode field of a filter element using the index
only: in this case, the you need not specify the address field.
set. The default is modifying the accessMode field of a filter element using the index
only: in this case, the you need not specify the address field.
length
If the address is specified, the length must be specified.
•
For NSAP, the length is in bits.
•
For E164, the length is in bytes.
plan Address
Plan:
e.164 or nsap. You may specify this field only if you also specify the
address field.
Default = nsap
list Address
List:
calling or called. You may specify this field only if you also specify
the address field.
Default = calling
index
Order in which filters are set.
Range: 1–65535
Default =
Default =
1
AccessMode Specify the access mode (permit or deny) to whether accept or deny the call on the
port if the address pattern-matching succeeds.
Default = permit