Cisco Systems Cisco MGX 8850 Manuale Utente
6-48
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6
Logical Node, Port, and Signaling Commands
cnfsigdiag
cnfsigdiag
Configure Signaling Diagnostic
The cnfsigdiag command lets you create a filter table for signaling diagnostics or disable signaling
diagnostics. Signaling diagnostics are disabled by default.
diagnostics. Signaling diagnostics are disabled by default.
The ATM signaling diagnostics are tools for troubleshooting call failures in the network and should not
be enabled while the switch is operating.
be enabled while the switch is operating.
Cards on Which This Command Runs
PXM45
Syntax
cnfsigdiag {[enable | disable | index]}
[-cldaddr nsap-address]
[-clgaddr nsap-address]
[-cldaddrmask atm-address-mask]
[-clgaddrmask atm-address-mask]
[-casttype {all | p2p | p2mp}]
[-clrcause clear-cause-code]
[-connctgy {all | svc | svp | swvc | swvp}]
[-inport portid]
[-outport portid]
[-maxrec max-num-records ]
[-scope {all | ext | int}]
[-servctgy {all | cbr | rtvbr | nrtvbr | ubr | abr}]
[-status {active | inactive}]
Syntax Description
enable,
disable, or
index
disable, or
index
Enable or disable signaling diagnostics or configure an index.
Specify the diagnostics index number for the filter table and enter the diagnostics
configuration mode. The range for index is 1–50. If you do not specify an index, the
enable or disable condition globally applies to all signaling diagnostics.
configuration mode. The range for index is 1–50. If you do not specify an index, the
enable or disable condition globally applies to all signaling diagnostics.
Default: disable
-cldaddr
The nsap-address is the filter for ATM signaling call failures against this called
address.
address.
Default: NULL
-clgaddr
The nsap-address is the filter for ATM signaling call failures against this calling
address.
address.
Default: NULL