Cisco Systems Cisco MGX 8850 Manuale Utente
6-55
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6
Logical Node, Port, and Signaling Commands
cnftrapip
cnftrapip
Configure Trap IP
The cnftrapip command lets you configure the trap IP for Cisco WAN Manager. You can then use the
command dsptrapip to confirm the value.
command dsptrapip to confirm the value.
Before you use cnftrapip:
1.
The SNMP agent must be installed.
2.
The switch’s interface must have an IP address. (To assign an IP address to a switch’s interface, use
ipifconfig.)
ipifconfig.)
For information about installing the SNMP agent for CWM, see Cisco WAN Manager Installation for
Solaris, Release 10.
Solaris, Release 10.
Cards on Which This Command Runs
PXM45
Syntax
cnftrapip <ip address>
Syntax Description
Related Commands
dsptrapip, dsptrapmgr, addtrapmgr, deltrapmgr
Attributes
Example
Assign IP address 172.27.27.184 to the switch, then use the dsptrapip command to check it.
SanJose.7.PXM.a > cnftrapip 172.27.27.184
SanJose.7.PXM.a > dsptrapip
Trap IP Address :172.27.27.184
SanJose.7.PXM.a >
ip address The
switch’s ethernet IP address on which the traps are configured.
Log: log
State: active
Privilege: GROUP1