Cisco Systems Cisco MGX 8850 Manuale Utente
6-100
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6
Logical Node, Port, and Signaling Commands
dsppnsysaddr
dsppnsysaddr
Display PNNI Port System Addresses
—displays the PNNI system address table.
The dsppnsysaddr command displays addresses in the system address table. The system address table
only contains static addresses.
only contains static addresses.
Note
This command does not belong to the RA module.
Cards on Which This Command Runs
PXM45
Syntax
dsppnsysaddr
[ ilmi | uni | static | host | all ]
Syntax Description
Display Contents
The ATM address, the address prefixes, and the peer group identifier share some default field values, as
shown in
shown in
.
The following parameters are displayed for each node.
ilmi
Display all of the ilmi addresses in the peer group.
uni
Display all of the uni addresses in the peer group.
static
Display all of the static addresses in the peer group.
host
Display all of the host addresses in the peer group.
all
Display all of the addresses. This is the default.
ATM Address
(displayed but not
labeled)
(displayed but not
labeled)
Display the PNNI node ATM address. This is a 20-byte, formatted hexadecimal
string. Like all PNNI addresses, identifiers, and prefixes, this value is portrayed
as a string of hexadecimal “nibbles.” One or several pairs of nibbles entail each
parameter field.
string. Like all PNNI addresses, identifiers, and prefixes, this value is portrayed
as a string of hexadecimal “nibbles.” One or several pairs of nibbles entail each
parameter field.
Default:
shows the factory-set default.
Type
Display the type of address that you specified in the command line.
Range: ilmi, uni, static, host
Port id
The PNNI logical port identifier.
Range: 1–2147483648