Cisco Systems Cisco MGX 8850 Manuale Utente
7-22
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 7
SPVC and SVC Commands
cnfcdvtdft
cnfcdvtdft
Configure Cell Delay Variation Tolerance Default
For all connections of a particular service type on a PNNI logical port, cnfcdvtdft configures the default
number of microseconds for the cell delay variation tolerance (CDVT). The direction is ingress. The new
configuration applies to new incoming calls but not existing calls. You can execute cnfcdvtdft whether
the port is in the provisioning state (prior to addport on the service module) or administratively up.
number of microseconds for the cell delay variation tolerance (CDVT). The direction is ingress. The new
configuration applies to new incoming calls but not existing calls. You can execute cnfcdvtdft whether
the port is in the provisioning state (prior to addport on the service module) or administratively up.
Cards on Which This Command Runs
PXM45
Syntax
cnfcdvtdft <portid> <service_category>
[microseconds]
Syntax Description
Related Commands
dspcdvtdft
Attributes
portid
The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also
[shelf.]slot[:subslot].port[:subport]. See also
.
<service_category> Service
type:
cbr, rtvbr, nrtvbr, ubr, or abr.
micro seconds
The number of microseconds for CDVT.
Range: 0–2147483647
Default = 250,000
Log: log
State: active
Privilege: GROUP1