Cisco Systems Cisco MGX 8850 Manuale Utente
8-17
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 8
Network Optimization Commands
dsprteoptcnf
dsprteoptcnf
Display Route Optimization Configuration
Display the current configuration for route optimization. The configuration itself originates with the
cnfrteopt command. The dsprteoptcnf display shows the following:
cnfrteopt command. The dsprteoptcnf display shows the following:
•
The node-level threshold for route optimization. It is the percent of reduction in the route cost.
•
Identity of the optimization target by port and VPI/VCI range.
•
Enable status of optimization.
•
Interval between times that optimization begins.
•
Start and stop times for route optimization.
Cards on Which Command Executes
PXM45
Syntax
dsprteoptcnf
Syntax Description
This command takes no parameters.
Related Commands
cnfrteopt, opte, dsprteoptstat, cnfrteoptthld
Attributes
Example
Display the current route optimization for the switch. No optimization has been configured on any ports.
pop20two.7.PXM.a > dsprteoptcnf
Configuration of Route Optimization:
Percentage Reduction Threshold: 30
Port Enable VPI/VCI Range Interval Time Range
1:2.1:2 no
1:2.2:3 no
Log: no log
State: active, standby
Privilege: ANYUSER