Cisco Systems Cisco MGX 8850 Manuale Utente
9-77
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 9
Troubleshooting Commands
dspchantests
dspchantests
Display Channel Tests—display results of tstdelay or tstconseg commands.
The tstdelay or tstconseg commands test the integrity of the path of a connection in the ingress and
egress directions, respectively. After you successfully start a test through tstdelay or tstconseg, the
returned message directs you to use dspchantests or dspcon to see the results. The same test results
presented by dspchantests appears in the dspcon display, but dspchantests shows only the test results.
egress directions, respectively. After you successfully start a test through tstdelay or tstconseg, the
returned message directs you to use dspchantests or dspcon to see the results. The same test results
presented by dspchantests appears in the dspcon display, but dspchantests shows only the test results.
Cards on Which This Command Runs
AXSM
Syntax
dspchantests <ifNum> <vpi> <vci>
[-num <count>]
Syntax Description
Related Commands
tstdelay, tstconseg, dspcon
Attributes
ifNum
The logical port number. The range for AXSM is 1–60.
vpi
The VPI range for the SVC or SPVC is 1–255.
vci
The VCI range for a VCC SPVC is 32–65535. For a VPC, the only VCI value for an
SPVC is 0.
SPVC is 0.
-num
(Optional) A keyword that indicates an aggregate connection count follows.
number
The number of connections to display.
Log: no log
State: active, standby
Privilege: ANYUSER