Cisco Systems Cisco MGX 8850 Manuale Utente
9-134
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 9
Troubleshooting Commands
dspxbaralm
dspxbaralm
Display Crossbar Alarms—display severity of crossbar alarms.
The dspxbaralm command shows whether a crossbar alarm is minor, major, or critical. The display
shows status on both the active and standby PXM45.
shows status on both the active and standby PXM45.
Note
This low-level command normally applies to software or hardware development and therefore is not
useful for troubleshooting at the network or node level. For troubleshooting at the switch level, use
dspndalms and dspswalms.
useful for troubleshooting at the network or node level. For troubleshooting at the switch level, use
dspndalms and dspswalms.
For fault isolation after you execute dspxbaralm, you can survey the possible errors (illustrated in the
example). The following is a top-down sequence of alarm-related commands:
example). The following is a top-down sequence of alarm-related commands:
1.
dspndalms
2.
dspswalms
3.
dspxbaralm
4.
dspxbarerrcnt
Cards on Which This Command Runs
PXM45
Syntax
dspxbaralm
Syntax Description
This command takes no parameters.
Attributes
Related Commands
dspxbar, dspxbarerrcnt, dspxbarerrthresh, dspndalms, dspswalms
Log: no log
State: active
Privilege: ANYUSER