Cisco Systems Cisco MGX 8850 Manuale Utente
2-31
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2
Shelf Management Commands
cnfserialif
cnfserialif
Configure Serial Interface
The cnfserialif command lets you change the data rate on a serial interface on the PXM45-UI-S3 back
card. The two types of serial ports are the console port and the maintenance port. These ports provide
user-access for controlling the switch. The default speed n a serial interface is 9600 bits per second, but
higher speed terminals are frequently available.
card. The two types of serial ports are the console port and the maintenance port. These ports provide
user-access for controlling the switch. The default speed n a serial interface is 9600 bits per second, but
higher speed terminals are frequently available.
Each port connects to a different type of terminal implementation. Refer to the Cisco MGX 8850 Routing
Switch Software Configuration Guide for a description of how to use these physical ports for switch
control.
Switch Software Configuration Guide for a description of how to use these physical ports for switch
control.
Cards on Which This Command Executes
PXM45
Syntax
cnfserialif <port#> <speed>
Syntax Description
Related Commands
delserialif, dspserialif
Attributes
Example
Configure the console port to have a data rate of 19200 bits per second.
node19.8.PXM.a > cnfserialif 2 19200
port#
Specifies the physical port:
•
1=maintenance port.
•
2=console port.
speed
Specifies a data rate in bits per second. Valid entries are 1200, 2400, 4800, 9600,
19200, and 38400.
19200, and 38400.
Log: no log
State: active
Privilege: SUPER_GP