Q-Logic SB-RACKKIT Dépliant

SANbox 5000 Series Fibre Channel Switch Rack Mounting Guide 

© 2008 QLogic Corporation. Specifications are subject to change without notice. All rights reserved worldwide. QLogic and the QLogic logo are registered trademarks of QLogic Corporation.
All other brand and product names are trademarks or registered trademarks of their respective owners. Information supplied by QLogic Corporation is believed to be accurate and reliable.
QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice, to make changes in product design or specifications.

D

D

 QLogic Corporation   26650 Aliso Viejo Parkway     Aliso Viejo, CA 92656   949.389.6000     www.qlogic.com

Europe Headquarters   QLogic (UK) LTD.  Quatro House   Lyon Way, Frimley   Camberley Surrey, GU16 7ER UK    +44 (0) 1276 804 670

Install the switch rails on the switch using two 
screws to secure each rail. The switch can be 
mounted flush or with a 1.25 inch setback 
depending on how you match the holes.

1. Switch rails, flush mount

2. Switch rails, with setback

3. Screws, 10-32 x 3/8

Extend the rack rails to fit the inner dimensions of 
the rack. The rail flanges on both ends fit inside 
the rack. Be sure that the inner rail is toward the 
front.

If the rack holes are square, use a centering 
washer with each screw.

Fasten the rail flanges to the rack at both ends 
with two screws using the upper and lower holes.

1. Screws

2. Inner rack rail

3. Centering washer

1. Slide the switch and rail assembly into the rack 

rails.

2. Fasten the switch to the rack with two screws: 

one through each switch rail flange.

1. Screws