Q-Logic 59042-07 A Manuale Utente
4 – Installation
Install Firmware
59042-07 A
4-21
0
4.2.9
Cable Devices to the Switch
Connect cables to the SFP transceivers and their corresponding devices, and
then energize the devices. Device host bus adapters can have SFP (or SFF)
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber optic
cable connectors are designed for SFP transceivers, while SC-type connectors
are designed for GBICs. Duplex cable connectors are keyed to ensure proper
orientation. Choose the fiber optic cable with the connector combination that
matches the device host bus adapter.
then energize the devices. Device host bus adapters can have SFP (or SFF)
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber optic
cable connectors are designed for SFP transceivers, while SC-type connectors
are designed for GBICs. Duplex cable connectors are keyed to ensure proper
orientation. Choose the fiber optic cable with the connector combination that
matches the device host bus adapter.
GL_Ports self configure as FL_Ports when connected to loop of public devices or
F_Ports when connected to a single device. G_Ports self configure as F_Ports
when connected to single public devices. Both GL_Ports and G_Ports self
configure as E_Ports when connected to another switch.
F_Ports when connected to a single device. G_Ports self configure as F_Ports
when connected to single public devices. Both GL_Ports and G_Ports self
configure as E_Ports when connected to another switch.
4.3
Install Firmware
The switch comes with current firmware installed. You can upgrade the firmware
from the management workstation as new firmware becomes available. You can
use the SANsurfer Switch Manager application or the CLI to install new firmware.
from the management workstation as new firmware becomes available. You can
use the SANsurfer Switch Manager application or the CLI to install new firmware.
Note:
You can load and activate version 4.2 firmware on an operating switch
without disrupting data traffic or having to re-initialize attached devices.
If you attempt to perform a non-disruptive activation without satisfying
the following conditions, the switch will perform a disruptive activation:
without disrupting data traffic or having to re-initialize attached devices.
If you attempt to perform a non-disruptive activation without satisfying
the following conditions, the switch will perform a disruptive activation:
The current firmware version is a 4.x version that precedes the
upgrade version.
upgrade version.
No changes are being made to switches in the fabric including
powering up, powering down, disconnecting or connecting ISLs,
and switch configuration changes.
powering up, powering down, disconnecting or connecting ISLs,
and switch configuration changes.
No port in the fabric is in the diagnostic state.
No zoning changes are being made in the fabric.
No changes are being made to attached devices including
powering up, powering down, disconnecting, connecting, and HBA
configuration changes.
powering up, powering down, disconnecting, connecting, and HBA
configuration changes.
Ports that are stable when the non-disruptive activation begins, then
change states, will be reset. When the non-disruptive activation is
complete, SANsurfer Switch Manager sessions reconnect
automatically. However, Telnet sessions must be restarted manually.
change states, will be reset. When the non-disruptive activation is
complete, SANsurfer Switch Manager sessions reconnect
automatically. However, Telnet sessions must be restarted manually.