Niles Audio 8 Manuale Utente
45
8. The IR/RF Test LED
The RF test LED may be plugged into an IR flasher output to determine if the jack (or
the flasher driver circuitry) is working properly. The Test LED should light red when
commands are issued from the remote and output via that port. The Test LED may also
be plugged into the jack on the bottom lip of the Tabletop Remote to determine if the
tactile buttons are making contact.
the flasher driver circuitry) is working properly. The Test LED should light red when
commands are issued from the remote and output via that port. The Test LED may also
be plugged into the jack on the bottom lip of the Tabletop Remote to determine if the
tactile buttons are making contact.
Note: Testing the Tabletop Remote with the Test LED DOES NOT determine if the
Remote is transmitting RF, only that the buttons are making electrical contact.
Remote is transmitting RF, only that the buttons are making electrical contact.
Also Note: DO NOT PLUG THE TEST LED INTO THE AUDIO, VIDEO, OR
ASSIGNABLE 12V CONTROL VOLTAGE OUTPUTS. YOU WILL DESTROY THE
TEST LED.
ASSIGNABLE 12V CONTROL VOLTAGE OUTPUTS. YOU WILL DESTROY THE
TEST LED.
Figure 13 Adjusting Flasher Levels