Netgear GS724TS-100NAS Manuale Utente

The following table describes the information available for each entry in the address table.

Dynamic Address Configuration

Use the Dynamic Addresses page to set the amount of time to keep a learned MAC address 
entry in the forwarding database. The forwarding database contains static entries, which are 
never aged out, and dynamically learned entries, which are removed if they are not updated 
within a given time.

To access the Configuration page, click Switching 

 Address Table  Advanced  Dynamic 

Addresses.

 

To configure the Dynamic Address setting: 

Specify the number of seconds the forwarding database should wait before deleting a 

learned entry that has not been updated. IEEE 802.1D-1990 recommends a default of 

300 seconds. You may enter any number of seconds between 10 and 1000000. The 

factory default is 300.

VLAN ID

Specifies the VLAN ID on which the IGMP Snooping Querier is 
administratively enabled and for which VLAN exists in the VLAN database.

MAC Address

A unicast MAC address for which the switch has forwarding and/or filtering 
information. The format is a six-byte MAC address with each byte separated 
by colons. For example, 00:0F:89:AB:CD:EF.

Interface

The port where this address was learned: that is, this field displays the port 
through which the MAC address can be reached.

Status

The status of this entry. The possible values are:

Static: The entry was added when a static MAC filter was defined.

Learned: The entry was learned by observing the source MAC 

addresses of incoming traffic, and is currently in use.

Management: The system MAC address, which is identified with 

interface c1.