Netgear GS724TS-100NAS Manuale Utente
166
|
Chapter 5: Managing Device Security
GS716Tv2 and GS724Tv3 Software Administration Manual
The Profile Summary table shows the rules that are configured for the profile, as the following
table describes.
table describes.
Click Refresh to update the page with the most current information.
Access Rule Configuration
Use the Access Rule Configuration page to configure the rules about what systems can
access the GS716T or GS724T Web interface and what protocols are allowed.
access the GS716T or GS724T Web interface and what protocols are allowed.
To access the Access Rule Configuration page, click Security
Access, and then click the
Access Control
Access Rule Configuration link.
Before you create access rules, make sure:
•
An access profile exists.
•
The access profile is deactivated.
Field
Description
Rule Type
Identifies the action the rule takes, which is either Permit or Deny.
Service Type
Displays the type of service to allow or prohibit from accessing the switch
management interface:
management interface:
•
SNMP
•
HTTP
•
HTTPS
Source IP Address
Displays the IP Address of the client that may or may not originate
management traffic.
management traffic.
Mask
Displays the subnet mask associated with the IP address.
Priority
Displays the priority of the rule. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.
management request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.