Netgear GS724TS-100NAS Manuale Utente

To configure global 802.1X settings:

Select the appropriate radio button in the Port Based Authentication State field to 

enable or disable 802.1X administrative mode on the switch. 

Enable. Port-based authentication is permitted on the switch.

If 802.1X is enabled, authentication is performed by a RADIUS 

server. This means the primary authentication method must be 
RADIUS. To set the method, go to Security > Management 
Security > Authentication List and select RADIUS as method 1 for 
defaultList. For more information, see 

Disable. The switch does not check for 802.1X authentication before allowing traffic 

on any ports, even if the ports are configured to allow only authenticated users.

Select the appropriate radio button in the Guest VLAN field to enable or disable the guest 

VLAN supplicant mode. 

Enabled. When no 802.1X supplicant is authenticated on a port, the port still provides 

limited network access, as determined by a guest VLAN configured on the 
authentication server.

Disabled. A guest VLAN cannot be used for unauthorized ports.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

If you change the settings, click Apply to apply the new settings to the system.

Port Authentication

Use the Port Authentication page to enable and configure port access control on one or more 
ports.

To access the Port Authentication page, click Security 

 Port Authentication, and then click 

 Port Authentication link.

Use the horizontal scroll bar at the bottom of the browser to view all 

the fields on the Port Authentication page. The figures on the 
following page are both images of the Port Authentication page.