Netgear M4100-50-POE Manuale Utente

This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for a 
designated interface and direction.

show access-lists interface <slot/port> [in|out] 

IPv6 Access Control List (ACL) Commands

This section describes the commands you use to configure IPv6 ACL settings. IPv6 ACLs 
ensure that only authorized users have access to specific resources and block any 
unwarranted attempts to reach network resources. 

The following rules apply to IPv6 ACLs:

The maximum number of ACLs you create is 100, regardless of type.

The system supports only Ethernet II frame types.

The maximum number of rules per IPv6 ACL is hardware-dependent.

This command creates an IPv6 access control list (ACL) identified by <name>, consisting of 
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a 
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 
access list.

If an IPv6 ACL by this name exists, this command enters IPv6-Access-List config mode to 
allow updating the existing IPv6 ACL.

The CLI mode changes to IPv6-Access-List Config mode when you 

successfully execute this command.

Privileged EXEC

Type of access list (IP, IPv6, or MAC).

Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access 

list.

An optional sequence number might be specified to indicate the order of this access list 

relative to other access lists already assigned to this interface and direction. A lower 
number indicates higher precedence order. If a sequence number is already in use for 
this interface and direction, the specified access list replaces the currently attached 
access list using that sequence number. If the sequence number is not specified by the 
user, a sequence number that is one greater than the highest sequence number currently 
in use for this interface and direction is used. Valid range is (1–4,294,967,295).