Fujitsu eLux NG S26361-F2600-L134 Manuale Utente
Codici prodotto
S26361-F2600-L134
www.
myelux
.com
eLux
®
NG
Build # 27
62
3.11.1 Local Printer
The default printer definition “lp” is preset to a local printer. This means you can attach a
printer to the Thin Client parallel port and print without additional configuration (depending on
your printer, you may need to activate the filter).
The main memory is used to buffer print data. The following describes how to configure a local
printer.
printer to the Thin Client parallel port and print without additional configuration (depending on
your printer, you may need to activate the filter).
The main memory is used to buffer print data. The following describes how to configure a local
printer.
To configure a local printer
1. Connect a printer to the parallel, serial
or USB port of the Thin Client.
2. From
the
Setup
tab, click the Printer
subtab.
3. Click
New
.
4. Enter the name of the printer in the
Printer settings
dialog box.
5. Click the interface type in the
Connection type
list.
• Parallel: If the printer is attached to
a parallel port.
• Serial (COM1): If the printer is
attached to the external serial port.
Click the baud rate from the Baud
rate
Click the baud rate from the Baud
rate
list. To set COM port settings,
see “3.12.4 COM Ports.”
• USB: If the printer is attached to a
USB port.
Figure 39: Printer definition dialog box
(settings for local printer shown)
6. From
the
Filter
drop-down list, select Text to print from a local shell (print shell
command: lpr –P <printer name>). Select PCL2 for the PCL 2 protocol. Select
None
None
to disable filtering. In this case, the print data will be sent to the printer in the
output format of the application. See also “Filtering” below.
7. Citrix MetaFrame ICA servers have autocreated printer capabilities. Autocreated
printer means a printer definition is automatically created on the MetaFrame server
when you connect via ICA. It is now possible to configure eLux NG to use these
capabilities. Enter the following:
Driver name
when you connect via ICA. It is now possible to configure eLux NG to use these
capabilities. Enter the following:
Driver name
: Enter the driver for your printer. Note: The printer driver name must be
exactly the same as the driver installed on the MetaFrame server. See the installed
printer driver list on the MetaFrame server if you are unsure. The MetaFrame server
will not autocreate a printer if the printer driver you entered here is not installed on the
MetaFrame server (check capitalization and spelling!).
Default
printer driver list on the MetaFrame server if you are unsure. The MetaFrame server
will not autocreate a printer if the printer driver you entered here is not installed on the
MetaFrame server (check capitalization and spelling!).
Default
: Sets the printer to your default printer on the MetaFrame server.
8. Click
OK
in the Printer definition dialog box and Apply in the Printer subtab.
Filtering
To configure the filter, you must determine which page description language is being used by
the application and by the printer. The two most common are PostScript® from Adobe and
Printer Control Language (PCL®) from Hewlett Packard.
To configure the filter, you must determine which page description language is being used by
the application and by the printer. The two most common are PostScript® from Adobe and
Printer Control Language (PCL®) from Hewlett Packard.