3com CRWXR10095A Manuale Utente
Configure Employee Access Services
57
Click 802.1X Policy tab. Select Enabled. Set EAP Type to
Pass-Through.
Pass-Through.
Click Choose Available. Select the RADIUS server group.
Click Finish. Click Finish again.
6 Setup VLANs on the WX switches.
From the Create VLANs wizard, click VLAN Setup. Select the VLAN ID
number. Enter the VLAN name and the IP address.
number. Enter the VLAN name and the IP address.
Click VLAN Member Selection tab. From Available Members, select
port(s). Click Add
port(s). Click Add
Click Spanning Tree tab. Select STP options.
Click Spanning Tree Port Setup tab. Select STP port options. Click
Finish.
Finish.
Example: Configure
Employee Access
The following detailed steps provide an example of how to configure
Employee services. You will:
Employee services. You will:
In general, these same steps are required to configure other services, too.
You can refer back to this section, using the summary list or the task
table, with configuration options for “Configure Guest Access Services”
on page 69 or “Configure Voice over Wireless IP Service” on page 77.
You can refer back to this section, using the summary list or the task
table, with configuration options for “Configure Guest Access Services”
on page 69 or “Configure Voice over Wireless IP Service” on page 77.
Create a Service Profile
A service profile contains the configuration for the service you want to
offer, such as employee access, guest access, or VoWIP.
offer, such as employee access, guest access, or VoWIP.
For more information about service profiles, see “Wireless
Configuration” on page 36. For more information about service sets, see
“Which Services To Provide?” on page 30.
Configuration” on page 36. For more information about service sets, see
“Which Services To Provide?” on page 30.