Omega -C4EIT/-EIT Manuale Utente

4.4  Default IP Address
The iServer is shipped with a default IP address of 192.168.1.200 and Subnet Mask
of 255.255.255.0. If you are going to use a Web browser or Telnet program to
access the iServer using its default IP address, make sure that the PC from which
you’re establishing the connection has an IP address that is in the same range as
the iServer’s IP address (192.168.1.x, where x can be any number from 1 to 254).

Your PC’s IP address cannot be the same as the iServer’s IP address.

You also need to make sure that your PC’s Subnet Mask is 255.255.255.0. This is a
good way to access the iServer over the network and make any configuration
changes needed. 

If 192.168.1.200 is already in use on your network, connect the iServer directly to
your computer using a CAT5 Ethernet cable (either straight or cross-over cable will
be detected by the iServer) and proceed as described above.

To verify a good connection to the iServer, from a DOS prompt on your computer
type “ping 192.168.1.200” and press Enter. You should get a reply as shown in
Figure 4.1.

13