Enterasys Networks 6000 Manuale Utente

The Device View

2-48

Managing the Module

To set your desired operational mode:

1.

Click on the Speed, Duplex, or Flow Control list box to display the menu of 
available options; click to select the operational mode you wish to set. 

2.

Click on the Apply button to save your changes.

For ports which have been configured to operate in Auto Negotiate mode, this list box 
allows you to select which of the operational modes available to the port will be advertised 
to the negotiating link partner.

During Auto Negotiation, each of the link partners will advertise all selected modes. Of 
the selected modes, the highest mode mutually available will automatically be used. If 
there is no mode mutually advertised, no link will be achieved.

If you have manually configured specific operational modes for your 100Base-TX port or 
if you are configuring a 100Base-FX port, the Auto Negotiation Technologies list box 
does not apply.

The Auto Negotiation Technologies list box has the following column headings:

This column specifies whether the operational mode listed in the far right column of the 
list box will be advertised to the link partner. Only those operational modes supported by 
the local port (those with a “yes” listed in the Local column) can be advertised. Valid 
values are Enabled (the mode is supported and will be advertised), Disabled (the mode is 
supported but will not be advertised), and “---” (the mode is not supported).

Indicates whether the operational mode listed in the far right column of the list box is 
supported by the local port.

Indicates whether the operational mode listed in the far right column of the list box is 
supported by the remote port.