Siemens 6ED1050-1AA00-0BE8 Manuale Utente
LOGO! software
9.2 Connecting LOGO! to a PC
LOGO!
316
Manual, 04/2011, A5E03556174-01
Note
You can switch earlier versions up to 0BA3 with/without display to PC ↔ LOGO mode as
You can switch earlier versions up to 0BA3 with/without display to PC ↔ LOGO mode as
follows:
1. Switch off the power supply to LOGO!.
2. Remove the cover or the memory, battery, or combined memory/battery card and
1. Switch off the power supply to LOGO!.
2. Remove the cover or the memory, battery, or combined memory/battery card and
connect the cable to this socket.
3. Switch on power.
LOGO! switches automatically to PC ↔ LOGO mode.
The PC can now access LOGO! For information on this function, refer to the LOGO!Soft
LOGO! switches automatically to PC ↔ LOGO mode.
The PC can now access LOGO! For information on this function, refer to the LOGO!Soft
Comfort Online Help.
For more information on LOGO! versions without display, refer to the Appendix topic "LOGO!
For more information on LOGO! versions without display, refer to the Appendix topic "LOGO!
Closing the PC ↔ LOGO! mode
When the data transfer is completed, the connection to the PC is shut down automatically.
Note
If the circuit program created with LOGO!Soft Comfort is password protected, both the circuit
If the circuit program created with LOGO!Soft Comfort is password protected, both the circuit
program and the password are downloaded to LOGO!. The password prompt is enabled at
the end of the data transfer.
The upload of a password protected program created in LOGO! is only possible after the
The upload of a password protected program created in LOGO! is only possible after the
correct password is entered in LOGO!Soft Comfort.
Connecting a standard Ethernet cable (for LOGO! 0BA7 only)
To connect LOGO! 0BA7 to a PC, you need a standard Ethernet cable. Network
communication between LOGO! 0BA7 and the PC takes place with Ethernet only.