Extreme networks 12800 Series Manuale Utente
Installing the BlackDiamond 12800 Series Chassis
BlackDiamond 12800 Series Switches Hardware Installation Guide
70
Initial Management Access
After your switch has completed all power on self-tests, it is operational. You can log in and configure
an IP address for the default VLAN (named default).
an IP address for the default VLAN (named default).
NOTE
In BlackDiamond switches, the management port on the MSM is part of the management VLAN by default. Refer to
for further details.
Connecting Equipment to the Console Port
Connection to the console port is used for temporary direct local management. This connection is not
intended to be left in place for normal (long-term) use.
intended to be left in place for normal (long-term) use.
The console port settings are:
●
Baud rate—9600
●
Data bits—8
●
Stop bit—1
●
Parity—None
●
Flow control—XON/XOFF
The terminal or PC with terminal-emulation software that you connect to an Extreme Networks switch
must be configured with these settings. This procedure is described in the documentation supplied with
the terminal.
must be configured with these settings. This procedure is described in the documentation supplied with
the terminal.
Appropriate shielded serial cables are available from your local supplier, or you can make your own. To
ensure the electromagnetic compatibility of the unit, use only shielded serial cables that are grounded
on both ends. For information about the DB-9 console plug connector, see
ensure the electromagnetic compatibility of the unit, use only shielded serial cables that are grounded
on both ends. For information about the DB-9 console plug connector, see
.
Logging In for the First Time
After your switch has completed all power on self-tests, it is operational. You can log in and configure
an IP address for the default VLAN (named default).
an IP address for the default VLAN (named default).
NOTE
In BlackDiamond switches, the management port on the MSM is part of the management VLAN by default. Refer to
for further details.
To manually configure the IP settings:
1
Connect a terminal or PC with terminal-emulation software to the MSM on the BlackDiamond
switch or to the console port on the Summit switch.
switch or to the console port on the Summit switch.
2
At your terminal, press [Return] one or more times until you see the login prompt.