Extreme networks 17001 Manuale Utente

Summit Family Switches Hardware Installation Guide

At each side, fasten the mounting bracket to the back rack post using suitable screws.

After the switch is secured to the rack, install and connect power supplies as described in 

 or 

.

The Summit X650 series switch is shipped without installed power supplies. The switch accommodates 
one or two Summit X650 power supply units (PSUs).

An AC power cord is not included with the Summit X650 AC PSU. AC power cords for use in the US 
and Canada from Extreme Networks or from your local supplier. The cord must meet the following 
requirements:

●

The power cord must be agency-certified for the country of use and rated for 100-240 V AC.

●

The power cord must have an IEC 320 C13 connector for connection to the PSU.

●

The power cord must have an appropriately rated and approved wall plug applicable to the country 
of installation.

●

For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm

2

) minimum; over 6 feet, the 

minimum wire size is 16 AWG (1.0 mm

2

).

For additional power cord requirements, see 

.

SH_084