Extreme networks 17001 Manuale Utente
Summit Family Switches Hardware Installation Guide
185
Installing an EPS-150DC Power Supply
NOTE
Install the EPS-T2 before you begin installing the EPS-150DC.
WARNING!
Always be sure that the DC circuit is de-energized before connecting or disconnecting the DC wiring harness at the
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
Installing an EPS-150DC unit consists of the following tasks:
●
Connecting the DC wiring harness to the DC source voltage (see
).
This task must be performed by a licensed, qualified electrician.
●
Installing an EPS-150DC unit in an EPS-T2 (see
)
●
Connecting the DC wiring harness to the DC power socket on the EPS-150DC (see
)
●
Perform these four tasks in the order they are described.
Connecting the DC Wiring Harness to the DC Source Voltage
The EPS-150DC power module must be connected to a DC power source. A three-wire, 6-foot long DC
wiring harness (
wiring harness (
) is included with the EPS-150DC unit. The DC wiring harness mus t be
properly connected to the DC source voltage at your facility by a qualified electrician before the
connector on the wiring harness can be attached to the DC power supply socket on the rear of the unit.
See
connector on the wiring harness can be attached to the DC power supply socket on the rear of the unit.
See
specifications to be used in connecting the wiring harness to the DC source voltage.
WARNING!
Wiring the EPS-150DC DC wiring harness to your facilities DC source voltage must be performed by a qualified,
licensed electrician. After the wiring harness is connected to a permanent DC voltage source by a qualified, licensed
electrician, you can remove, replace and maintain the ESP-150DC without further electrician assistance. However,
always be sure that the DC circuit is de-energized before connecting or disconnecting the DC power connection at
the rear of the EPS-150DC unit.
licensed electrician. After the wiring harness is connected to a permanent DC voltage source by a qualified, licensed
electrician, you can remove, replace and maintain the ESP-150DC without further electrician assistance. However,
always be sure that the DC circuit is de-energized before connecting or disconnecting the DC power connection at
the rear of the EPS-150DC unit.
CAUTION
The DC wiring harness must be properly connected to a DC main circuit breaker or fuse rated no greater than 20 A.
Provide proper connection and strain relief on the DC wiring harness in accordance with all local and national
electrical codes.
electrical codes.