HP (Hewlett-Packard) 2610 Manuale Utente
1-8
Introducing the Switch
Front of the Switch
Front of the Switch
In
tr
o
d
u
c
in
g
th
e
Sw
itc
h
Port LEDs
The port LEDs provide information about the individual switch ports.
Table 1-3.
Port LEDs
Switch LEDs
State
Meaning
Switch 2610 non-PWR Series
Port LEDs
Displays port link information, network activity information, whether the port is
configured for full-duplex operation, or the speed of the connection depending on the
LED Mode selected. See “LED Mode Select Button and Indicator LEDs” on the next page
for more information.
configured for full-duplex operation, or the speed of the connection depending on the
LED Mode selected. See “LED Mode Select Button and Indicator LEDs” on the next page
for more information.
Mini-GBIC
LEDs:
Link
LEDs:
Link
Flashing
orange
orange
One of the following conditions exist:
• the mini-GBIC is not supported by the current software
• the mini-GBIC is not a genuine ProCurve Mini-GBIC and is not supported
• the mini-GBIC is an “A” version in a switch that requires a “B” version
• the mini-GBIC is not supported by the current software
• the mini-GBIC is not a genuine ProCurve Mini-GBIC and is not supported
• the mini-GBIC is an “A” version in a switch that requires a “B” version
or later.
Link and Mode
(green)
(green)
On for 2
seconds
seconds
Both the Link and Mode LED turn on solid for 2 seconds and then go to
normal operation. This indicates the mini-GBIC has been recognized by the
switch.
normal operation. This indicates the mini-GBIC has been recognized by the
switch.
Switch 2610-PWR Series
Link
(green)
(green)
On
The port is enabled and receiving a link indication from the connected
device. In PoE mode, indicates that the port is configured to enable PoE
power delivery to the connected device.
device. In PoE mode, indicates that the port is configured to enable PoE
power delivery to the connected device.
Off
One of these condition exists:
• no active network cable is connected to the port
• the port is not receiving link beat or sufficient light
• the port has been disabled through the switch console, the web browser
• no active network cable is connected to the port
• the port is not receiving link beat or sufficient light
• the port has been disabled through the switch console, the web browser
interface, ProCurve Manager, or other network management tool.
• In PoE mode, indicates that the port is configured such that PoE power
delivery is disabled.
Flashing
1
The port has failed self test. The switch Fault, and Self Test LEDs will flash
simultaneously.
simultaneously.
Mode (green)
Depending on the mode selected, displays the following:
• Connection speed information
• network activity information
• PoE power delivery status
See “LED Mode Select Button and Indicator LEDs:” below for more information.
• Connection speed information
• network activity information
• PoE power delivery status
See “LED Mode Select Button and Indicator LEDs:” below for more information.
1
The flashing behavior is an on/off cycle once every 1.6 seconds, approximately.