Belkin F1DP108AEA Guida Utente

29

29

se

ct

io

n

 

1

2

3

4

5

6

7

8

Now that you have connected your console and servers to your SMB CAT5 KVM 
Switch, it is ready for use. Select connected servers by either the direct-access 
port selectors, located on the front panel of the SMB CAT5 KVM Switch, using 
the On-Screen Display, or by using hot key commands through the console 
keyboard. It takes approximately 1–2 seconds for the video signal to refresh 
after switching servers. Re-synchronization of the mouse and keyboard signals 
also occurs. This is normal operation and ensures that proper synchronization is 
established between the console and the connected servers.

Switch to the next or previous port with simple keyboard hot key sequences 
using the “Scroll Lock” key and either the “Up” or “Down” arrow keys. To 
send commands to the SMB CAT5 KVM Switch, the “Scroll Lock” key must 
be pressed twice within two seconds. The SMB CAT5 KVM Switch will beep, 
confirming that it is in hot key mode. . Next, press the “Up” arrow key and the 
SMB CAT5 KVM Switch will switch to the next port. Press the “Down” arrow key 
to switch to the previous port. (Refer to diagram below.) 

With a single-switch configuration (no daisy-chained KVM switches), you can 
switch directly to any port by entering the two-digit number of the port you wish 
to access. For example, if you press “Scroll Lock”, “Scroll Lock”, “02”, the SMB 
CAT5 KVM Switch will switch to the server on Port 2 located on BANK 00. 
(Refer to diagram below.) 

Switch to previous active port,  

“Down” arrow

Switch to BANK 00, Port 2 (02)

Switch to next active port, “Up” arrow.