Milan Technology E-FX-HB-0800 Manuale Utente
INSTALLATION
Optionally Install Expansion Adapter
WARNING: Remove AC line cord from power source before installing
expansion adaptor in E-FX-HB-xx00. Failure to observe this warning could
result in personal injury or death.
expansion adaptor in E-FX-HB-xx00. Failure to observe this warning could
result in personal injury or death.
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing Expansion Adapter in the E-FX-HB-xx00. Failure
to observe this caution could result in damage to, and subsequent failure of,
Expansion Adapter.
precautions when installing Expansion Adapter in the E-FX-HB-xx00. Failure
to observe this caution could result in damage to, and subsequent failure of,
Expansion Adapter.
To install the expansion adapter in the E-FX-HB-xx00:
1.
Locate expansion adapter plate at back of E-FX-HB-xx00.
2.
Remove expansion adapter plate by using flatblade screwdriver to
remove two (2) screws that secure expansion adapter plate to back
of E-FX-HB-xx00.
remove two (2) screws that secure expansion adapter plate to back
of E-FX-HB-xx00.
NOTE: Retain screws for step 5. (Optionally discard expansion
adapter plate.)
adapter plate.)
3.
Carefully slide expansion adapter, component side up, into
installation space revealed by removal of expansion adapter plate.
installation space revealed by removal of expansion adapter plate.
CAUTION: Do NOT force the connection. Failure to observe this
caution could result in equipment damage and subsequent failure.
4.
Press component on expansion adapter securely against internal
mating E-FX-HB-xx00 component until expansion adapter faceplate
is flat against E-FX-HB-xx00 chassis.
mating E-FX-HB-xx00 component until expansion adapter faceplate
is flat against E-FX-HB-xx00 chassis.
5.
Secure expansion adapter by installing retained screws through
expansion adapter into E-FX-HB-xx00 chassis.
expansion adapter into E-FX-HB-xx00 chassis.
YES
•
Continue at step 7.
7.
Is one (or more) of the 100BASE-FX STAT(us) LEDs illuminated
continuously?
YES
continuously?
YES
•
Continue at step 10
NO
•
Continue at step 8.
8.
Does one (or more) of the 100BASE-FX STAT(us) LEDs blink on
and off?
YES
and off?
YES
•
Check fiber cables for proper connection.
•
Verify that TX and RX cables on E-FX-HB-xx00 are connected to RX
and TX ports, respectively, on terminal device. (See page 9.)
and TX ports, respectively, on terminal device. (See page 9.)
•
Ensure that terminal device(s) is/are powered.
•
Contact Technical Support: (800) 260-1312.
NO
•
Continue at step 9.
9.
Is one (or more) of the 100BASE-FX STAT(us) LEDs dark?
YES
YES
•
The port is (or ports are) partitioned; investigate the attached
terminal device(s).
terminal device(s).
•
Contact Technical Support: (800) 260-1312.
NO
•
Continue at step 10.
10.
Is one (or more) of the 100BASE-FX ACT(ivity) LEDs
illuminated?
YES
illuminated?
YES
•
The port is (or ports are) operational and receiving data.
NO
•
Disconnect and reconnect the 100BASE-FX cable to restart the
initialization process.
initialization process.
•
Restart the terminal device(s) to restart the initialization process.
•
Contact Technical Support: (800) 260-1312.
Expansion Adapter Plate