Milan Technology MIL-SM2401M Manuale Utente
80
4-6. Xmodem Upgrade
1. While booting the switch, press the X key to start the Xmodem routine on
the device.
2. Pressing X will cause the switch Xmodem application to begin and cause
the baud rate to change to 57600 bps. You will need to disconnect the
cable connected to the serial port, and change the baud rate of your
hyper-terminal application on your laptop to 57600 bps, then connect the
cable and reconnect to the switch.
cable connected to the serial port, and change the baud rate of your
hyper-terminal application on your laptop to 57600 bps, then connect the
cable and reconnect to the switch.