Lucent Technologies P332MF Manuale Utente
Chapter 6
Cajun Campus CLI – Layer 2
74
Cajun P332MF User’s Guide
Set interface Command
Use the
set interface command to configure the management interface on
the Master agent of the stack.
The syntax for this command is:
set interface inband <vlan> <ip_addr> <netmask>
set interface inband <vlan> <ip_addr> <netmask>
Example:
Cajun_P330-N# set interface inband 1 149.49.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.
Cajun_P330-N# set interface inband 1 149.49.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.
Set port level Command
Use the
set port level command to set the priority level of a port. Packets
traveling through a port set at normal priority should be served only after packets
traveling through a port set at high priority. Packets traveling with a 802.1p priority
header are not affected by this command.
traveling through a port set at high priority. Packets traveling with a 802.1p priority
header are not affected by this command.
The syntax for this command is:
set port level <mod_num>/<port_num> {normal|high}
set port level <mod_num>/<port_num> {normal|high}
Example:
To set the priority level for port 2 on module 1 to high:
Cajun_P330-N# set port level 1/2 high
Port 1/2 port level set to high.
To set the priority level for port 2 on module 1 to high:
Cajun_P330-N# set port level 1/2 high
Port 1/2 port level set to high.
inband
Interface name used for the management
vlan
The number of the VLAN to be used for management
ip_addr
IP address used for managing the stack
netmask
Subnet mask of the management interface
normal
Set the port priority to regular.
high
Set the port priority to high.