Motorola P120 Manuale Utente
112
Cajun P120 User’s Guide
Configuring the Cajun P120 TFTP parameters
To configure the Cajun P120 TFTP parameters:
1
Establish a Telnet session with the Cajun P120 (“Establishing a Telnet Session
(Ethernet port or modem)” on page 26 for details).
(Ethernet port or modem)” on page 26 for details).
2
Log in to the Privileged level as follows:
a
a
Type login at the C
ajunP120>
prompt.
b
Enter the password (the default value is lucent):
Enter password: lucent
The prompt should change to CajunP120-priv#.
Enter password: lucent
The prompt should change to CajunP120-priv#.
3
Enter the TFTP configuration mode by typing the following:
CajunP120-priv#set TFTP
CajunP120-priv#set TFTP
4
Type list at the
TFTP>
prompt
5
You will be asked to enter the TFTP parameters one by one as follows (for a
detailed explanation of the parameters, refer to “TFTP Configuration Group
(TFTP)” on page 64):
tftp>tftp-op [limited]? Ensure that the value is set to “limited”
tftp>tftp-ip [149.49.42.58 ]? Enter the IP address of the TFTP server.
tftp>tftp-filename [c:\p120\p120.lst ]? Enter the name of the lst file which you
prepared in the previous step, including the full path
(e.g., c:\p120\p120.lst).
detailed explanation of the parameters, refer to “TFTP Configuration Group
(TFTP)” on page 64):
tftp>tftp-op [limited]? Ensure that the value is set to “limited”
tftp>tftp-ip [149.49.42.58 ]? Enter the IP address of the TFTP server.
tftp>tftp-filename [c:\p120\p120.lst ]? Enter the name of the lst file which you
prepared in the previous step, including the full path
(e.g., c:\p120\p120.lst).
6
Once you have entered all the parameters, the
CajunP120-priv#
prompt will be
displayed. Type WRITE to save the parameters. The following message will
appear on the display:
Writes this configuration into the memory. Dynamic parameters will take affect
immediately. All other parameters will only take affect after powering the switch
off/on.
Save the new configuration (y/n)
appear on the display:
Writes this configuration into the memory. Dynamic parameters will take affect
immediately. All other parameters will only take affect after powering the switch
off/on.
Save the new configuration (y/n)
?
Enter
Y
to save the new configuration.
Start the Software Download
Now that the Cajun P120 is configured, you can start the download procedure:
1
Run the TFTP server on the computer with the Cajun P120 files.
2
Type the command
tftp-cmd start
at the CLI prompt. This starts the
download.
3
If you wish, you can monitor the download status by typing the command
status
status
at the CLI prompt.
Once the download has finished, you should receive the following message:
FTP transfer has finished successfully
FTP transfer has finished successfully
Reset the Cajun P120
In order to complete the download process, you need to reset the Cajun P120
before proceeding.
before proceeding.