Motorola P120 Manuale Utente
Chapter 6
Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide
45
Using the SHOW Command
The
show
command is used to display the current settings for a particular group of
parameters. If you have never changed parameter settings, then these are the
factory default values.
factory default values.
The following example will display the current settings for the IP group:
CajunP120> show ip
Listing the Groups You Can Set
If you enter
set
on the command line, a list of the groups that can be set with this
command displays.
Note: This is useful for displaying the syntax for use in your configuration.
The available groups are:
CajunP120-priv#
set
Group list:
mibII-syst
MIB-II system group params
Cam
Cam parameters
ip
Management IP parameters setup.
IP-multi-
cast
IP-multicast parameters
STA-GEN
Parameters for configuring general spanning tree.
STA-PORT
Parameters for configuring spanning tree per port.
P120
Port configuration group
vlan
Vlan group
copy-port
Destination (network analyzer) and source ports setup
tftp
TFTP parameters setup.
snmp
Configuration of SNMP community names and trap
managers
managers